This O-Ring drive belt is a direct replacement for models 270, 275, 280 and 290 Norwalk juicers.

This V drive belt is a direct replacement for the hydraulic pump drive belt on Norwalk juicers. Made specifically for the Norwalk models 235 through the early 270 models. The drive surface of the bely has an actual "V" shape that fits down into the V pulley. These belts can become worn and can harden over time. This condition will allow the belt to slip or break.

Machined from aluminum, this upper drive pulley was very seldom used and only on a few Norwalk 275s during a transitional period. It was specifically designed for the Norwalk juicers that incorporate the "O-Ring" style belt drive, but became obsolete shortly after it's introduction. Typically the standard "V" drive pulley is used with both, the O-ring combination and "V" belt application as the upper pulley for most istallations. It comes with the pulley and the set screw.

Machined from aluminum, this upper drive pulley is specifically designed for the Norwalk juicers that incorporate the "V" style belt drive. It comes with the pulley and the set screw.

Machined from aluminum, this lower drive pulley is specifically designed for the Norwalk juicers that incorporate the O-Ring style belt drive. It comes with the pulley and the set screw.

Machined from aluminum, this lower drive pulley is specifically designed for the Norwalk juicers that incorporate the "V" style belt drive. It comes with the pulley and the set screw.