This switch housing is used on the Norwalk 290 juicer to acatuate the internal microswitch (Not Included). This is a direct replacement for the two switches mounted on the side of the unit for easy access. To complete this assembley, see the microswitch that is also available and snaps into these switch housings.

These micro switches, used on the Norwalk 290, snap onto the external switch housing found on the machine's left side. They are  a direcr replacement for the factories micro switches.

This is the power cord for the Norwalk 290 or other units that have the standard three contactor configuration. With the right angle female end, it makes the connection point more in the back of the machine a streamlined application.

This is the power cord for the Norwalk 290 or any units that accept the standard 3 prong plug design.

This electric relay was used exclusively in the Norwalk 290. It is located under the stainless cover on the bracket with the internal switch

This on/off switch is for the Norwalk 290 juicer specifically. The switch is configured with (2) terminal blade connections, just as the original Norwalk 290 was.

This power cord, with harness, is a direct replacement for the power cord on Norwalk models 265 through models 280.

This is a replacement switch for the Norwalk 290. Located on the inside of the unit and not visible until the covers are remove, this switch is configured with (5) blade terminals on the back and mounted on the same bracket as the electrical relay.

This replacement switch fits the earlier Norwalk juicers with the (4) terminals on the back. For models 260-265-270-275-280 only.

This is the internal switch and relay found in a Norwalk 290 juicer. Includes the 90 degree bracket.